Compaq AA-RHGWC-TE manual Expansion PCI Drawer

Figure 7–3: Rear View of Expansion and Primary PCI Drawers

I/O Riser 1I/O Riser 0

Expansion PCI Drawer		Console Serial
		Bus Node ID Module
		PCI Drawer Node ID
		CSB Connector
		Local Terminal/
	Primary PCI Drawer
		COM1/Port
		PCI Drawer Node ID
		CSB Connector
		Console Serial
	Standard I/O Module	Bus Node ID Module
		ZK-1751U-AI

7.3Configuring Partitioned GS80, GS160, or GS320 Systems in a TruCluster Configuration

An AlphaServer GS80/160/320 system can be a member of a TruCluster Server configuration. Alternatively, any AlphaServer GS80/160/320 hard partition can participate as a member system, provided that the partition meets the hardware requirements that Section 7.2 describes.

The following section covers configuring a single partition AlphaServer GS80/160/320 system as multiple hard partitions in a TruCluster Server configuration. The description covers the case of a newly installed system that is to be used as two member systems in a TruCluster Server configuration.

7.3.1Repartitioning a Single-Partition AlphaServer GS80/160/320 as Two Partitions in a Cluster

The information in this section assumes that this is a new AlphaServer GS80/160/320 system with hardware installed, the system management console is connected for the first partition, a terminal emulator window is open for the first partition, and that the system has been powered up and tested as a single partition. Also, this section assumes that you have determined which QBBs to use in each partition. Although the procedure specifies two hard partitions, the maximum for a GS80 system, it will work

Using GS80, GS160, or GS320 Hard Partitions in a TruCluster Server Configuration 7–7