Example
Changing Parameters
A configuration consists of several parameters. The default factory configuration has a starting set of parameters. Your print jobs may require different parameter settings from the default that is provided. This section provides an example procedure for changing and saving individual parameter values.
Example
The following procedure shows how to change and save the settings for the Unidirectional option. Use these basic guidelines to navigate the configuration menus and change other parameters.
If you think the configuration for your printer has already been changed from the default, you should load the default configuration before starting this procedure (page 63).
OFFLINE
CONFIG.
CONTROL
* = Factory Default
. . . |
| PRINTER |
|
|
|
|
|
| |
| CONTROL |
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
| Unidirectional |
| PMD Fault |
| Slow Paper |
| Power Saver | |
|
|
|
|
|
|
| Slew |
| Time |
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
| |
| Disable* | Enable* | Disable* |
| 15* - 60 Min. | ||||
| Enable | Disable | Enable |
| Instant | ||||
NOTE: Once you change active emulations, any changes to the previously selected emulation will be gone unless they have been saved.
Table 4. Parameter Change Example Procedure
Step | Key | Result | Notes |
1. Make sure the printer is on. Raise the printer cover.
2.ONLINE
OFFLINE
CONFIG. CONTROL
3.
+
ENTER SWITCH UNLOCKED
OFFLINE
CONFIG. CONTROL
Allows you to make configuration changes.
55
