Parallel Submenu

Dataproducts Submenu

IMPORTANT The Dataproducts parameters in the printer must be set the same as the Dataproducts interface in the host computer. Otherwise, the printer might not work online, and data characters from the computer might not print or might print as “garbled” text.

* = Factory Default

Parallel

(from page 103)

Dataproducts

Data Bit 8

Enable*

Disable

PI Ignored

Enable*

Disable

Data Polarity

Standard*

Inverted

Data Request Strobe Polarity Pol.

Standard* Standard*

Inverted Inverted

Buffer Size in

K

8* (1-16)

The Dataproducts submenu provides the options and settings available to configure the interface as required for your application. These options and available settings are outlined in the following paragraphs.

Data Bit 8

Enable. Allows access to the extended ASCII character set.

Disable. The printer interprets bit 8 of each incoming data character as a zero, regardless of its actual setting.

PI Ignored

The PI (Paper Instruction) signal is used to control vertical paper motion.

Enable. Ignores the PI signal and treats the data as characters or control codes.

Disable. Causes the printer to interpret the eight data lines as VFU commands when the PI signal is true.

Data Polarity

The Data Polarity parameter must be set to match the data polarity of your host computer.

Standard. Does not expect the host computer to invert the data.

Inverted. Expects the data received on the data lines from the host computer to be inverted. Ones become zeros, and vice-versa.

109

Page 109
Image 109
Compaq P5000 Series setup guide Dataproducts Submenu, PI Ignored