Denso BHT-7500S, BHT-7500W user manual Downloading, File

[ 2 ] Downloading

If you download a file having the same name as one already used in the user area of the target memory in the BHT, the newly downloaded file replaces the old one.

￿

￿ ￿

￿

DOWNLOAD￿

1:FILE￿ ￿

Selecting "2: DOWNLOAD" on the SYSTEM MENU calls up the screen shown at left.

2:HT<-->HT COPY

1 FILE	: Downloads a user program
	file or data file to the user
	area of the BHT.

2HT<-->HT COPY : Downloads all of the files, system parameters, and cal- endar clock data stored in the connected BHT.

This function enables copy- ing between the BHTs.

For the preparation to be made preceding the start of this function, refer to NOTE below.

Select a desired item by using the numerical keys

or and keys, and the selected item becomes highlighted. Then press the ENT key.

To return to the SYSTEM MENU, press the C key.

NOTE Preparation for Copying between the BHTs

Before downloading to the BHT from another BHT, make the following prepa- ration:

¥At each BHT, set the interface port. The default is an optical interface (Optical).

Interface setting procedure: Starting on the SYSTEM MENU, select "4:SET SYSTEM," "5:COMMUNICATION," and "3:COM PORT." On the SET COM DEFAULT PORT screen, select the optical interface (Optical) or direct-con- nect interface (Connector) of "2:SYSTEM MODE."

¥When using the direct-connect interface, pull out the connector cover on each BHT to expose the direct-connect interface port. Connect the BHTs via those ports with the direct-connect interface cable (having 3-pole mini ste- reo plugs). For the details about the cable, refer to Chapter 3, Section 3.3.

¥On the uploading BHT, run System Mode and select "3:UPLOAD" and "3:HT<- ->HT COPY."

46