Denso BHT-7500W, BHT-7500S user manual Interfacing with the Host Computer

Chapter 5. Handling the CU-7000 (Option)

5.4.3 Interfacing with the Host Computer

This section describes how to start communication with the host computer in System Mode. The same may apply when you use a user program.

(1)Turn the host computer on.

(2)Plug the AC adapter of the CU-7000 into the wall socket.

(3)Make sure that the BHT is turned off, then set it on the CU-7000.

(4)Turn the BHT power on and run System Mode. Set the communications environ- ments (communications protocol, interface port, communications parameters, and protocol options).

Regarding the communications protocol: When using Ir-Transfer Utility C/Ir- Transfer Utility E on the host computer, select the BHT-Ir protocol; when using Transfer Utility, select the BHT-protocol.

Regarding the interface port: Select the optical interface port.

(5)On the host computer, initiate a communications program (e.g., Ir-Transfer Utility C/Ir-Transfer Utility E/Transfer Utility, or equivalent).

(6)To transfer data stored in the BHT to the host computer, select "3: UPLOAD" on the SYSTEM MENU in System Mode. To transfer data from the host computer to the BHT, select "2: DOWNLOAD." (For details, refer to Chapter 2, Section 2.5.)

The BHT and the host computer will start communications with each other via the CU-7000. The DATA LED will come on upon start of communications. After completion of communications, the LED will go off.

(7)Unplug the AC adapter of the CU-7000 from the wall socket.

161