DeWalt WP54AG manual accesspoint\TFTP -i 192.168.168.1 PUT accesspointxxx.img

Step 5:

From the Start menu, click Run and type cmd. When the command prompt window appears, type in the following command:

X:\recovery\TFTP -i 192.168.168.1 PUT image_name.IMG, where X refers to your CD drive and image_name.IMG to the firmware filename found in the Recovery folder of the Product CD.

Step 6:

If you have downloaded a newer firmware and have saved it in your local hard disk as: C:\accesspoint\accesspointxxx.IMG, then replace the command with this new path and firmware name. In our example:

C:\accesspoint\TFTP –i 192.168.168.1 PUT accesspointxxx.img

The recovery process will now take place. You can check the diagnostic LED to monitor the progress of the recovery process.

When firmware restoration has completed, reboot the access point and it will be ready to operate.

177