DeWalt WP54AG manual 192.168.168.1

Models: WP54AG

1 205
Download 205 pages 47.68 Kb
Page 40
Image 40

This table describes the parameters that can be modified in the Management Port Setup page.

 

Parameters

 

Description

 

IP Address

 

When the DHCP server of the access point is enabled (unless you

 

 

 

set a different DHCP Gateway IP Address), this LAN IP Address

 

 

 

would be allocated as the Default Gateway of the DHCP client.

 

 

 

The IP address of your Access point is set by default to

 

 

 

192.168.168.1.

 

 

 

 

 

Network Mask

 

The Network Mask serves to identify the subnet in which your

 

 

 

Access point resides. The default network mask is 255.255.255.0.

 

 

 

 

 

Management

 

(Optional) As a bridge Access Point, the access point does not

 

Gateway IP

 

usually communicate with devices on other IP subnets. However,

 

 

 

the Management Gateway here acts as the equivalent of the

 

 

 

Default Gateway of a PC, to allow the access point to

 

 

 

communicate with devices on different subnets. For instance, if

 

 

 

you want to access the access point from the Internet or from a

 

 

 

router on the LAN, enter the router IP address in the

 

 

 

Management Gateway IP field.

 

 

 

The Management Gateway IP address of your access point is set

 

 

 

to nil by default.

 

 

 

 

The next two fields (DHCP Start IP Address and DHCP End IP Address) allow you to define the range of IP addresses from which the DHCP Server can assign an IP address to the LAN.

DHCP

Start

IP

This is the first IP address that the DHCP server will assign. The

Address

 

 

value that you input here should belong to the same subnet as

 

 

 

your access point. For example, if the IP address and network

 

 

 

mask of your access point are 192.168.168.1 and 255.255.255.0

 

 

 

respectively, the DHCP Start IP Address should be 192.168.168.X,

 

 

 

where X can take any value from 2 to 254. It is pre-set to

 

 

 

192.168.168.100.

 

 

 

 

DHCP

End

IP

This is the last IP address that the DHCP server can assign. It

Address

 

 

should also belong to the same subnet as your access point. For

 

 

 

instance, if the IP address and network mask of your access point

 

 

 

are 192.168.168.1 and 255.255.255.0 respectively, the DHCP End

 

 

 

IP Address should be 192.168.168.X, where X can take any value

 

 

 

from 2 to 254. It is pre-set as 192.168.168.254.

 

 

 

 

29

Page 40
Image 40
DeWalt WP54AG manual 192.168.168.1