DeWalt WP54AG manual To Enable Parallel Broadband

TO ENABLE PARALLEL BROADBAND

Before you begin, ensure that each of the access point within the network is properly configured to connect to its individual broadband Internet account. Then ensure that either:

!each access point is connected to an Ethernet port in the network as illustrated above or

!the access points are interconnected by WDS or

!the access points are wired to each other.

Finally, you are ready to access the web-based configuration of each of your access point to enable the Parallel Broadband feature. You will have to enable all the DHCP servers in all access points before enabling Parallel Broadband. Please note that you need to interconnect all access points

Step 1:

Under the CONFIGURATION command menu, click on Parallel Broadband.

Step 2:

Next simply select Enable and click the Apply button to make the changes effective.

Step 3:

Repeat this for the other access points in your network and they will communicate with each other and assign each new user to the access point that has the smallest load, so that there is approximately the same number of users on each access point.

Important:

If you have only one unit of the access point, you DO NOT need to implement the Parallel Broadband feature for broadband Internet sharing.

136