Dialogic® DSI SS7MD Programmer’s Manual Issue 3
7.3MTP Configuration Commands
The Message Transfer Part (MTP) configuration commands are:
•
•
•
•
•
MTP_CONFIG - Configure MTP
MTP_LINKSET - Configure a Linkset
MTP_LINK - Configure a Link
MTP_ROUTE - Configure a Route
MTP_USER_PART - Configure a Local User Part
7.3.1MTP_CONFIG – Configure MTP
Synopsis
The global configuration parameters for the Message Transfer Part (MTP).
Syntax
MTP_CONFIG <reserved1> <reserved2> <options>
Example
MTP_CONFIG 0 0 0x00040000
Parameters
MTP_CONFIG
Parameters
The MTP_CONFIG command includes the following parameters:
•<reserved1>, <reserved2>
These parameters are reserved for backwards compatibility only. For applications conforming to this release, these parameters should always be set to 0.
•<options>
A
—Bit 0 is set to 1 to disable the MTP3 message discrimination function (allowing the signaling point to receive all messages irrespective of the destination point code contained in the message) or 0 to allow the discrimination function to operate normally.
—Bit 1 is set to 1 to disable
—Bit 3 is set to 1 to cause MTP3 to generate a User Part Unavailable (UPU) message to the network on receipt of a message containing a Service Indicator (SI) value that has not been configured. If set to 0, the message will be discarded without sending the UPU message.
—Bit 8 is set to 1 to select ANSI operation; otherwise it should be set to 0.
—Bits 9 and 20 are used to select the point codes used in the MTP routing label as defined below:
Bit 9 | Bit 20 | Point Code | Description |
0 | 0 | ITU | |
|
|
|
|
0 | 1 | Japan | |
|
|
|
|
1 | x | ANSI |
X = indicates do not care
—Bit 10 is set to 1 for ANSI operation; otherwise it should be set to 0.
—Bit 11 is set to 1 for ANSI operation; otherwise it should be set to 0.
—Bit 18 is used to control MTP functionality in the event of detection of Remote Processor Outage (RPO). If set to 1, RPO is handled in accordance with the
129
