
Dialogic® DSI SS7MD Programmer’s Manual Issue 3
7.10MAP Configuration Commands
The MAP configuration commands are:
7.10.1MAP_CONFIG – Configure MAP
Synopsis
The MAP_CONFIG command provides the MAP operating parameters and, if used, must appear after the SCCP_SSR commands in the config.txt file. The use of this command is not required and MAP is configured with default values if the MAP_CONFIG command is not present.
Syntax
MAP_CONFIG <options>
Example
MAP_CONFIG 2
Parameters
The MAP_CONFIG command includes the following parameters:
•<options>
Specifies MAP protocol options as defined for the MAP Configuration Request message in the MAP Programmer’s Manual.
7.10.2MAP_TRACE – MAP Trace
Synopsis
The MAP_TRACE command is used to configure MAP to send trace messages to the trace module whenever a specific message type is sent or received. See the MAP Programmer’s Manual for details.
Syntax
MAP_TRACE <op_evt_mask> <ip_evt_mask> <non_prim_mask>
Example
MAP_TRACE 0xf 0xf 0x4
Parameters
The MAP_TRACE command includes the following parameters:
•<op_evt_mask> Output event trace mask.
•<ip_evt_mask> Input event trace mask.
•<non_prim_mask>
157