Dialogic® DSI SS7MD Programmer’s Manual Issue 3

Value

Meaning

 

 

 

Remove a duplex connection between two timeslots on the cross connect switch

6

and one timeslot on the CPU local bus. Use the local_stream and local_slot

 

parameters to specify both timeslots for disconnection.

 

 

 

Remove a connection between a switch timeslot and a CPU local bus timeslot.

 

Then create a simplex connection between the same CPU local bus timeslot

8

back to the switch timeslot. Use the local_stream and local_slot parameters to

 

specify the CPU local bus timeslot, and the source_stream and source_timeslot

 

to specify the switch timeslot.

 

 

 

Make a simplex connection between two CPU local bus timeslots. The

11

source_stream and source_slot parameters specify the source of the signal in

terms of liu_id and timeslot, respectively. The local_stream and local_slot

 

 

parameters specify the outgoing lLIU or CPU stream and timeslot, respectively.

 

 

 

Make a duplex connection between two CPU local bus timeslots. The

12

source_stream and source_slot parameters specify the source of the signal in

terms of liu_id and timeslot, respectively. The local_stream and local_slot

 

 

parameters specify the outgoing liu_id and timeslot, respectively

 

 

 

Remove a duplex connection between two CPU local bus timeslots. Use the

13local_stream and local_slot parameters to specify one timeslot and the source_stream and source_slot parameters to specify the other.

source_stream

The source_stream references the cross connect switch streams that should be used as a source for data. The parameter takes values in the range of 0 to 31. For some modes (for example, 11 and 12), this field is used to specify a local stream instead of a switch stream.

source_slot

The source slot references the timeslot from which to connect or disconnect to the cross connect switch stream. The source slot values are in the range 0 to 127.

dest_stream

The dest_stream references the cross connect switch streams that should be used as a destination for data. The parameter takes values in the range of 0 to 31.

dest_slot

The dest slot references the timeslot from which to connect or disconnect to the cross connect switch stream. The dest slot values are in the range of 0 to 127.

67

Page 67
Image 67
Dialogic DSI SS7MD manual Parameters to specify both timeslots for disconnection