
Dialogic® DSI SS7MD Programmer’s Manual Issue 3
6.2General Configuration Messages
General configuration messages are typically issued by the s7_mgt protocol configuration utility, in which case they need not, and should not, be generated by any user application software.
If the user elects not to use the s7_mgt protocol configuration utility, it is necessary for the application to build and send messages that:
•configure the ssd module
•reset each board
•configure each board
•optionally configure additional routes
The messages in the general configuration category include:
•SSD_MSG_RESET - SSD Reset Request
•SSD_MSG_RST_BOARD - Board Reset Request
•SSD_MSG_BOARD_INFO - Board Information Request
•MGT_MSG_CONFIG0 - Board Configuration Request
•MGT_MSG_L1_CONFIG - Layer 1 Configuration Request
•MGT_MSG_L1_END - Layer 1 Configuration End
•MGT_MSG_NTP_CONFIG - Network Time Configuration
6.2.1SSD_MSG_RESET – SSD Reset Request
Synopsis
Sets up ssd module
Note: When using the s7_mgt protocol configuration utility, this message is generated by s7_mgt and should not be generated by the user.
Format
|
|
| MESSAGE HEADER |
|
|
|
|
| Field Name | Meaning | |
|
|
|
|
type |
|
| SSD_MSG_RESET (0x7680) |
|
|
|
|
id |
|
| 0 |
|
|
|
|
src |
|
| Sending module ID |
|
|
|
|
dst |
|
| SSD_module_ID |
|
|
|
|
rsp_req |
|
| Used to request a confirmation. |
|
|
|
|
hclass |
|
| 0 |
|
|
|
|
status |
|
| 0 |
|
|
|
|
err_info |
|
| 0 |
|
|
|
|
len |
|
| 24 |
|
|
|
|
|
|
| PARAMETER AREA |
|
|
|
|
Offset |
| Size | Name |
|
|
|
|
0 |
| 1 | Reserved. Set to 0. |
|
|
|
|
1 |
| 2 | Reserved. Set to 0. |
|
|
|
|
3 |
| 1 | mgmt_id |
|
|
|
|
4 |
| 18 | Reserved. Set to 0. |
|
|
|
|
22 |
| 2 | num_boards |
|
|
|
|
Description
This message is used during initialization by the application to reset the ssd module and set up its
The confirmation message (if requested) indicates success with a status value of 0.
49