Dialogic® DSI SS7MD Programmer’s Manual Issue 3
Chapter 7: Configuration Command Reference
This chapter describes the commands and parameters used in the config.txt protocol configuration file. These commands are used by the s7_mgt protocol configuration utility to perform one time configuration of the protocol stack at startup.
The commands are logically grouped in the following categories:
•Physical Interface Configuration Commands
•Monitor Configuration Commands
•MTP Configuration Commands
•ATM Configuration Commands
•ISUP Configuration Commands
•TUP Configuration Commands
•SCCP Configuration Commands
•DTC Configuration Commands
•TCAP Configuration Commands
•MAP Configuration Commands
•INAP Configuration Commands
•IS41 Configuration Commands
117
