Chapter 10
Controlling Other Components
Setting Up Using Device Codes Scan
If the code for your device is not listed in the tables starting on page Codes First Left or if you could not find a code that worked for your device, use this procedure to scan the remote control’s memory for the device code. In the instructions below, the column on the left contains the instructions and the column on the right provides additional information.
Instructions | Additional Information |
|
|
1 Turn the device on. | Use the device’s front panel buttons or its remote |
| control. |
2Press and hold the mode button until all the other mode buttons light up, and then release the button. The mode button flashes.
For example, hold the TV mode button until all of the other mode buttons light. When you let go, TV will flash.
3For AUX mode only. Press 0 for TV, 1 for VCR, or 2 for a tuner, or amplifier. Then press the STAR (*) button.
4Press POWER.
5Press the UP or DOWN ARROW repeatedly until the device turns off.
6Press POUND (#).
7Turn the device back on and try some other buttons to make sure that they work also.
This step is for programming the type of device that will be programmed in AUX mode. If you’re not programming in AUX mode, skip to step 4.
This puts your remote in the scan mode.
As you press the UP or DOWN ARROW, the remote tries each code in the memory to see if it can turn off your device. When the device turns off, you have found a code that might work.
Note: The mode button for the device will flash rapidly eight times when you’ve scanned all the codes for that device.
The mode button flashes three times if you have entered the code correctly, and stores the code you found.
Sometimes POWER works when other buttons don’t. If using Limited Mode, also try VOLUME or MUTE.
8If necessary, repeat this procedure until you’ve tried all the codes.
You may need to repeat the scan to find the best code for your device.
Note: This process could take a long time, because of this remote’s very large
78
