Chapter 10

Tips

satellite receiver is reliably in one state or the other. To use discrete power commands, complete the following:

 

2

3

4

 

1

 

or

5

SAT

 

 

Press

 

 

 

Press

 

 

POWER

 

 

 

SAT Mode

 

Press VOLUME UP

Press any

 

until all mode

 

for discrete power on

button

Program the

buttons light up

 

or press VOLUME DOWN

to end this

 

 

for discrete power off

procedure

remote control

 

 

 

 

TIPS

If using a specific channel for TV2 (for example, channel 60), TV2’s remote control must be programmed with a TV2 channel before you can use RECOVER.

Place the channel sticker on the remote TV and write down the channel you use to watch DISH Network programming. The stickers are inside the front cover of this guide.

If you don’t want to accidentally change channels on your TV or VCR, place the remote control in Limited Mode, as described on page 76.

Make sure you have a remote control antenna connected so you can use Remote Control 2. See page 17 for instructions.

QUESTIONS

My remote doesn’t control my receiver or other components. What should I do?

Ensure the remote control is in the correct mode (page 76).

Check the batteries (page 17).

Check the remote control address (pages 73 and 79).

Check (page 17) or adjust (page 74) the remote control antenna.

Why does my receiver change channels or display menus at random? Your neighbor may have their remote control set on the same address. Change the address on your remote control and receiver as described on page 72. If that doesn’t help, you may have to install a UHF attenuator as described on page 75.

88

Page 36
Image 36
Dish Network 722k important safety instructions Power