Dish Network 722k important safety instructions Removing the Recover Button Channel Programming

Remote Controls

Sending Discrete Power On and Off

•On a remote TV, RECOVER must be programmed to tune your remote TV to the specific channel to receive TV2 programming (for example, channel 60), using the instructions on page 86.

Note: Press any remote control button other than RECOVER to end this procedure.

Note: If RECOVER is not programmed to a specific channel, RECOVER will first try to tune your TV to channel 3, then channel 4, and then other video inputs with each press of RECOVER. You may need to press RECOVER up to 30 times to recover your satellite TV video. If RECOVER is programmed to a specific channel (see page 86), RECOVER will tune the TV to the specific channel (for example, channel 60).

Removing the Recover Button Channel Programming

The following instructions describe how to reset RECOVER to restore satellite TV viewing by tuning your TV (or VCR) to channel 3, 4, and other inputs.

SENDING DISCRETE POWER ON AND OFF

Installers use remote control discrete power on and power off IR commands when programming macro commands into universal remotes. Using an on-only or off-only command is more effective than a toggle on/off command when trying to make sure the

87