Dish Network 722k important safety instructions TV1 Channel TV2 Channel Air/Cable

Chapter 12

Connecting to the Remote TVs (TV1 or TV2)

3Find three channels next to each other on one of your remote TVs that do not pick up any signals from over-the-air or cable broadcasts (they should show nothing but snow or static). These channels must fall in one of the two ranges below. For example, if you find that cable channels 75, 76, and 77 do not pick up any broadcasts, pick these channels since they fall into the range below for cable channels. Make sure these three channels on other remote TVs also do not pick up broadcasts.

•Air Mode - Select a channel between 21 and 69 if your TV(s) will be set in Air Mode.

•Cable Mode - Select a channel between 73 and 125 if your TV(s) will be set in Cable Mode.

Note: The remote TV(s) will have to be set to the same channel mode, either air or cable channel mode for this installation. See your TV user’s guide for instructions on how to set your TV to air or cable channel modes.

4Pick the channel in the middle of the three you selected in step 3. Write that channel down in the blank provided in step 5. For example, if the three channels you picked in the preceding step were air channels 60, 61, and 62, pick channel 61 and write it in the space provided in step 5.

5If your TV is in over-the-air mode for the channels you picked in step 4, circle “Air” below. If your TV is in cable mode for the channels you picked in step 4, circle “Cable” below. If you are using these instructions for TV1 and TV2, pick different channels (for example, Channel 60 for TV1 and Channel 64 for TV2).

TV1 Channel: TV2 Channel: Air/Cable

6Set all of your remote TV(s) to the channel mode (air or cable) you wrote in step 5.

7Tune all of your remote TV(s) to the channel(s) you wrote in step 5. This is the channel you will use to receive your satellite programming.

8Connect CH 21-69 OUT on the receiver to your existing wall cable outlet using a coaxial cable.

Note: If you do not have an existing in-home cable system, you will need to run coaxial cable to each TV in other rooms. If this is too difficult, you may want to contact a professional to do this installation.

9Place the yellow sticker on the CH 21-69 Out cable near where the cable attaches to the receiver. The stickers are located inside the front cover of this guide.

10Turn on the nearby TV (the TV that gets programming from the TV1 outputs).

11Make sure the receiver's green TV1 indicator is on.

12Press MENU. Select System Setup, Installation, and then Modulator Setup.

108