4To start learning commands for this mode:
•If you've found a code for that device, first program the code. Now press and release RECALL, then hold RECORD for about three seconds.
•If you have not programmed a code for that device, press and hold RECORD for three seconds.
5Point the front of the original device remote to face the small square (IR window) on the front,
6On the DISH Network remote control, press the button you want to teach.
7On the original device remote control, press and hold the button you want learned.
•If the DISH Network remote learns the command, the mode light blinks off and then back on.
•If the mode light blinks three times or remains lit, the DISH Network remote did not learn the command.
8After a button has learned a command suc- cessfully, repeat step 6 and step 7 until all commands you want have been learned.
9To end the learning sequence:
•Press one of the mode buttons on the DISH Network remote. This saves all the commands for that mode, and exits learning to return to normal remote control operation.
•To cancel learning, do not press any buttons on either remote control for at least 30 seconds. The DISH Network remote control times out and returns to normal operation.
Note that no learned commands are saved if the DISH Network remote control times out before completion.
Remote Controls
Controlling Other Components
To find and program the device code, use the instructions for Setting Up Using Device Code Tables on page 77 or Setting Up Using Device Codes Scan on page 78.
The mode button that you selected remains lit while learning.
You may need to try pressing the button on the original device’s remote several times for the DISH Network remote to learn the command.
The learning sequence also ends:
•If the remote runs out of memory for learned commands, it saves the commands you have learned for equipment in this mode, exits learning and returns to normal remote control operation. The DISH Network remote cannot learn additional commands.
•If the remote control batteries are too low for learning, all the mode buttons blink quickly eight times. Learning ends with no learned commands saved, and the DISH Network remote returns to normal operation.
Change the batteries.
81
