Emulex DCP_link manual Configuration

X.25 Configuration 7-19

6)In the Call Type field, accept the default value Permanent or press <Enter> to select On-Demandfrom the pop-up list.

Reminder: You must configure the X.25 Authentication Options in the X.25 Profile if you select “on- demand” as the Call Type.

On-Demand calls are established only when needed. The connections are terminated whenever the link is void of network data. Termination is determined by the Idle Line Time-out value. A connection failure is retried only when more network data is directed to the remote destination.

On-demand calls can be placed through either a specific interface or an interface group, but not both.

−You can display a list of Interface Group names by pressing <Enter>.

−Select an X.25 interface group from the list, then press <Enter>. Continue with Step 7 below.

OR

−If an Interface Group name isn’t specified, select Interface Name, then press <Enter> to display a list of X.25 interfaces.

The Select Interface pop-up window is displayed listing the configured X.25 interfaces. This read-only list allows you to select the name of the specific X.25 interface through which this WAN Call Destination can be accessed.

−Select an X.25 interface from the list, then press <Enter>.

Permanent - calls can be placed only through a specific interface; they cannot be directed to an interface group.

7)Interface Name: Press <Enter> and select an available Network Interface from the pop-up list.

8)In the Circuit Type field, accept the default value Switched Virtual Circuit (SVC), or press <Enter> to select Permanent Virtual Circuit (PVC).