Emulex DCP_link manual Configuring with INETCFG

Software Configuration 5-5

Configuring with INETCFG

Important: You must use INETCFG to configure the Emulex software and hardware you have installed in your server/router.

If INETCFG is not running, complete the following steps to load it: 1) At the server prompt, type

>LOAD INETCFG <Enter>

The Internetworking Configuration main menu is displayed.

Figure 5-1

Note: The first time you run INETCFG, you will be prompted to move all commands from Autoexec.ncf to other files that INETCFG uses. Answer Yes to this prompt.

2)If the Internetworking Configuration main menu is not displayed, please refer to the Emulex DCP_link Advanced Configuration Manual for instructions on transferring LAN driver, protocol, and remote access commands.

3)Select Boards, then press <Enter>.

The Configured Boards window is displayed.