Emulex DCP_link manual Running the Diagnostic, A-8 Appendix A

A-8 Appendix A

•options.386

•dmadcp.asm

•dmapc.asm

•dma.equ

•dcp286d.equ

•mac.equ

•scc.equ

•assem.bat

•build.bat

•dmatest.bat

•dmatest.doc

Check the diskette to make sure all these files are present. After you have done this, make a backup copy of the diagnostic diskette for regular use. If running the diagnostics from a hard drive, create a subdirectory in your hard disk, then copy the diagnostics to that subdirectory. In both cases, place the original Emulex diskette in a safe place.

Running the Diagnostic

The Diagnostic Platform can be used to configure and run diagnostics on several adapters at the same time. The adapter may be all the same type or any combination of supported models. The list of tests and their order of performance are individually configurable for each adapters. To run the diagnostic program, perform these steps:

1)Boot the system under DOS and insert the Emulex diagnostic diskette in drive A:

2)Set the default drive path to: A:

3)At the DOS prompt, type:

>A:dcpdiag3

The Diagnostic Main Menu appears. You are now ready to run the desired diagnostics.