Introduction
Hardware Requirements
In order to successfully install the Emulex DCP_link software, you must be running NetWare on a Novell approved hardware platform, or you must first install the Runtime version of Novell NetWare that is shipped with DCP_link. If you are running on a Novell approved hardware platform, you will need the following minimum configuration.
•An Intel (or equivalent) 80386 (minimum) based host server with ISA/EISA slot(s) available for WAN adapter(s).
•At least 16MB of system RAM.
•80 MB of available hard disk memory.
•(For
•NetWare certified LAN Network Interface Card (NIC) for local routing.
•A 3.5” floppy diskette drive.
You will need the following communications equipment:
•For analog lines, synchronous modems at both ends of the WAN connection
•DSU/CSU, synchronous modem, PBX, or T1 multiplexer.
•Cable connectors and adapters, as applicable, for
Software Requirements
To operate properly, your system software should be configured as follows:
•The system should start DOS from the hard disk. NetWare is started from DOS before it takes over the system hardware completely.
•Novell DOS 7 (included),