X.25 Configuration 7-21

This parameter specifies the maximum delay between attempts to establish a connection (the retry interval). The delay is set initially to 8 seconds and increases exponentially until the maximum retry interval is reached.

The range of time intervals is 00:00:00 to 23:59:59 (hh:mm:ss). For permanent calls, the default value is 10 minutes (00:10:00). For on- demand calls, the default value is 2 minutes (00:02:00).

14)In the Idle Line Time-outfield, if Call Type is set to On-Demand, accept the value shown or press <Enter> to change it.

This parameter specifies the amount of time that an on-demand call can be inactive before closing the connection.

The range of values is 00:00:00 through 23:59:59 (hh:mm:ss). The default value is 10 minutes (00:10:00).

15)In the Remote System ID field, press <Enter> to display a list of X.25 Remote System Ids. This parameter is needed only if Call Type is set to

On-Demand.

This parameter specifies the symbolic name (from 1 to 47 ASCII characters) of the remote peer system associated with this WAN Call Destination entry, typically the remote system server name.

16)Use the arrow keys to select a Remote System ID, then press <Enter> accept or press <Ins> to create a new Remote System ID.

If you press <Ins>, enter the symbolic name (from 1 to 47 ASCII characters) of the remote peer system associated with this WAN Call Destination entry in the window that appears, then press <Enter> and repeat the first part of this step.

To identify the proper WAN Call Destination the Remote System ID is accessed by the X.25 protocol stack. This is needed to restore an on- demand connection to a remote system that previously initiated a connection with this system.

Page 114
Image 114
Emulex DCP_link manual On-Demand