![](/images/new-backgrounds/1174523/174523225x1.webp)
7-20 Chapter 7
9)For SVC, enter the DTE Address in the Destination DTE Address field.
For PVC, enter the PVC number (which must be configured in the X.25 Profile). Press <Enter> for a list of configured PVC numbers.
NOTE: PVC Numbers may only be configured provided the Wan Call Circuit type is Permanent and the X.25 profile for that interface has been defined.
The PVC number must match the Logical Channel Number (LCN) assigned by the X.25 network service provider at subscription time.
10)In the Destination DTE Address field (if Circuit Type is Switched), type the address.
This is the X.121 DTE address (up to 15 digits, 0 through 9) assigned to the specific destination DTE.
11)In the Retry Mode field, accept the mode shown or press <Enter> to select another option from the
This parameter specifies the conditions under which a failed connection is retried. All connection failures are reported to the system console and to the Call Manager utility (CALLMGR).
The available options are Never Retry, Retry All Failures, Retry Self- Correcting Failures. The default is Retry
12)In the Retry Limit Handling field, press <Enter> to select the appropriate option from a
This parameter specifies the action taken when the connection retry interval exceeds the Retry Interval Limit (described in Step 12).
For permanent calls, connection retries can either continue indefinitely at the maximum retry interval (which supports unattended operation) or be terminated (the connection fails).
13)In the Retry Interval Limit field, accept the value shown or press <Enter> to change it.