Emulex DCP_link manual Circuit Type Permanent, the default, is the only option available

6-12 Chapter 6

NOTE: If you have not configured any Network Interfaces before attempting to configure a WAN Call Destination, you receive this message:

WAN network interfaces must be configured before WAN Call Destinations may be created.

5)Select EMX F Relay as the wide area medium. The Frame Relay Call Destination Configuration menu is displayed:

Figure 6-7 Call Destination Configuration

6)Interface Name: Press <Enter> to select the Network interface that has been defined for EMX F Relay.

7)Circuit Type: Permanent, the default, is the only option available.

8)DLCI Number: Press <Enter> to select the local DLCI (circuit number) entered in the Network Interfaces screen.

9)After defining all the necessary parameters, press <Esc> and select Yes to save the changes to the Frame Relay WAN Call Destination Configuration.