Emulex DCP_link manual Installing the Emulex Adapter

Hardware Installation 3-3

This section describes the procedure for installing the DCP286i-SBC, the DCP386i, and the DCP486e WAN adapter in your server/router. Brief troubleshooting procedures are also provided.

Installing the Emulex Adapter

To install the adapter perform these steps:

1)Turn off power to the system unit. Remove the power cord from the unit and the AC outlet.

2)Loosen attaching screw and remove the top cover of the system unit.

3)Remove the cover from an empty slot. The DCP286i-SBC and DCP386i may be installed in a 16-bit ISA and EISA slot. However, the DCP486e must be installed in an EISA slot.

4)Slide the board into the empty slot. Press firmly to seat the board.

5)Secure the board with the screw removed in step 3.

6)Replace the system unit cover and reconnect the power cord.

7)Connect cable.

Before connecting the external device, you may want to perform a complete functional test of the unit. Refer to Section 4 for instructions on running the diagnostics.