The message “Could not complete communicating configuration data” appears when you send settings to the print server.

Cause

What to do

 

 

This may happen when using

Run Command Prompt from the

a dial-up router.

computer on which EpsonNet

 

WinAssist/MacAssist is installed, and

 

then enter the following command:

 

Format: >ROUTE_ADD_the IP address

 

of the print server_ the IP address of the

 

computer (the under bar represents one

 

space)

 

Example:>ROUTEADD192.168.192.168

 

22.33.44.55.

Unable to start EpsonNet WebAssist.

Cause

What to do

 

 

You have not set the IP

Set the IP address for the print server

address for the print server.

using EpsonNet WinAssist, MacAssist,

 

the printer’s control panel, or the

 

arp/ping commands. You can check the

 

IP address on a status sheet. See

 

“TCP/IP” on page 59, “TCP/IP” on page

 

88, or “Setting an IP Address Using the

 

arp/ping Command” on page 244.

12

12

12

12

12

12

12

12

12

12

12

12

Troubleshooting 231