Setting the Interface Mode

The print server automatically selects an interface mode by default. If you want to change the interface mode of the print server, use EpsonNet Win/Mac/WebAssist or the jumpters on the print server.

Using EpsonNet Win/Mac/WebAssist

See the following pages to change the interface mode of the print server using EpsonNet Win/Mac/WebAssist:

❏To use EpsonNet WinAssist, see “Ethernet” on page 58.

❏To use EpsonNet MacAssist, see “Ethernet” on page 87.

❏To use EpsonNet WebAssist, see “Ethernet” on page 211.

Using jumpers on the print server

See the following steps to manually set an interface mode of the print server using jumpers.

1.Turn off your printer. If you are using an ink jet printer, unplug the power cord from the wall outlet.

2.Pull out the print server from the printer’s interface slot, and place it on an insulator such as a sheet.

3.Use the following table to change the jumper settings.

Note:

❏ All of the jumpers are opened by default.

238Troubleshooting