Loading backup data from a CD-R/RW drive

The following description is assumed that you have a CD-RW/CD-R disc which contains saved data.

<Note>

Do not carry out any VF160EX key operation until the access process to the CD-RW/CD-R disc is completed.

1.After turning on the VF160EX, insert the disc to the CD-R/RW drive.

5.While “BkUp” is flashing, press the [ENTER/YES] key.

The display shows the backup number and title, as well as recorded space.

f l a s h i n g

<Note>

If you load song data which is saved to more than one disc, set DISC-1first.

If you set the other disc and go on the following pro- cedure, the VF160EX automatically recognized that the disc order is not correct and the display shows “Wrong Disk” , followed by “Illegal No!” momentarily, and the disc is automatically ejected.

By rotating the [JOG] dial, you can select a desired pro- gram number/title from among available programs in the VF160EX current drive. You can also select “Eject”.

If you select “Eject” and press the [ENTER/YES] key, the disc is ejected

When you load song data which is saved to more than one disc, the display also shows the disc number cur- rently set. The example below shows DISC-1 is set.

2.Press the [SETUP] key to enter the setup mode.

The display shows the screen for selecting the setup menu.

3.Use the [JOG] dial to select (highlight) “Load PGM” and press the [ENTER/YES] key.

The display shows the screen for selecting a load device, where “IDE” is flashing.

f l a s h i n g

l i g h t i n g

6.While the desired backup number/title is shown on the display, press the [ENTER/YES] key.

The display shows the screen for creating a new program on the current drive, to which data will be loaded (“New PGM” lights).

f l a s h i n g

f l a s h i n g

l i g h t i n g

4.While “IDE” is flashing, press the [ENTER/YES] key.

Press the [ENTER/YES] key to display the CD-R/RW drive name, and then changes to the load mode select screen where "Bkup" (Backup) flashes.

To load saved data, select "BkUp". To load data from an audio CD, select "CD-DA".

Let's select "Bkup" here and go on to the following procedure.

See "loading from an audio CD" described later for details about how to use audio CD (CD-DA) discs.

f l a s h i n g

As described earlier, when loading data from a CD-RW drive, the VF160EX creates a new program on the cur- rent drive, which is the load destination. Therefore, “New PGM” is shown on the right of the flashing program num- ber. The program number for the newly created desti- nation program is the next number to the highest exist- ing program number. For example, if there are 8 exist- ing programs (“P01” through “P08”) on the current drive, the newly created program is numbered “P09”.

<Note>

If you rotate the [JOG] dial while the above screen (“Destn PGM Select”) is shown, you can select an exist- ing program on the current drive as the destination. However, as mentioned earlier, when loading data using CD-RW you cannot actually load data to the ex- isting program by overwriting the program data.

If you press the [ENTER/YES] key (see the next step) while selecting an existing program as the destina- tion, the display shows “Void!” and the VF160EX ig- nores the operation.

118

Page 118
Image 118
Fostex VF160EX operation manual 118, While IDE is flashing, press the ENTER/YES key