Trouble Shooting

A breakdown? If you suspect so, please read the fpllowing explanations before requesting repairs.

Troubles at Recording?

Input signal not indicated by the level meter ?

Level meter does not light up even though recording track is set and channel fader/master fader is raised to the "0" position.

Set the recorder to input monitor.

Press the [RECORD] key only. The key will blink in red and the READY track will be in the input monitor mode. The recorder output can be applied to each channel faders. The level meter is unable to function unless the READY track is changed to the input monitor mode.

For details, read pages 32-33 and 45-46.

When attempting to select a recording track for DIRECT recording, are there some tracks between 9- 16 that cannot be selected ?

Could there be some channels set to “INPUT” at setup of [INPUT]-[TRACK] ?

DIRECT recording is executed, basically, with all chan- nels in the “TRK” mode at setup of [INPUT]-[TRACK], as shown below. Should any one channel of 9-16 is set to “INPUT”, that channel cannot be set as a recording track at DIRECT recording.

RECORD

STOP

PLAY

REWIND

F FWD

AUTO PUNCH

CLIPBOARD PLAY

PREV

NEXT

 

LOCATE ABS 0

 

 

 

LOCATE REC END

 

 

*Level does not increase even though the channel fader is raised ?

Recording level will not increase although the READY track channel fader is raised to maximum (+6).

Adjust [TRIM] knob to a suitable level.

The level cannot be raised for small input signals if the [TRIM] knob is positioned at "LINE" (full CCW). Rotate the [TRIM] knob to just before the sound distorts.

LINE MIC

Sound adjusted by EQ cannot be recorded by DIRECT recording ?

When DIRECT recording, EQ cannot be applied.

Application of EQ at recording is permissible only at BUSS recording. Although EQ can be applied to the input sig- nal at DIRECT recording, this is strictly listening to the monitor sound only and the original sound will be re- corded without alteration.

However, when BUSS recording, EQ can be applied to each input signal and recorded.

PEAK

The monitor sound is not heard even though the input level/stereo buss L, R levels are being indicated by the meter ?

Although the READY track is set to input monitor, no sound is heard in the headphone although the meter is indicating the level.

Raise the [PHONES] knob.

No sound will be heard if the headphones adjuster is turned down. Also, if monitoring with an external moni- tor speaker, raise the [MON OUT] knob.

MON OUT PHONES

• Effect sound cannot be recorded at BUSS recording ?

Select source channel for the effect.

When BUSS recording, in order to record while apply- ing effect to the source channel, effect 1 or effect 2 must be selected together with selecting the source channel as shown in the schematic below. In the example below, input H and effect 1 are selected for the source channel. For details, read page 45.

0

10

0

10

149

Page 149
Image 149
Fostex VF160EX operation manual Troubles at Recording?, 149