Fostex VF160EX operation manual 131, Hint, Press the EXIT/NO key to exit the setup mode

On the contrary, when you set the load type to “Select”, the load destination program number for the secondly selected track is same as the firstly selected track. That is, all selected tracks are loaded to the same program.

11.Press the [ENTER/YES] key.

As with the firstly selected track, the secondly selected track (“02”, in this example) is set.

12.Operate the same procedure as above for selecting other tracks.

13.When completing selecting all desired tracks, press the [ENTER/YES] key while holding down the [RECORD] key.

The display shows “Data Loading!” while the remaining data amount (in MB) is counted down. You cannot cancel loading once it starts. Wait for a while until loading is completed. Loading more amount takes more time. When completing loading, “Load Completed!” is shown, while the audio CD is automatically ejected from the CD- R/RW drive.

14. Press the [EXIT/NO] key to exit the setup mode.

<Hint>

If you are going to load tracks 1 and 3 in the example above, instead of tracks 1 and 2, track 3 will be loaded to program 06 (see the screen example below).

However, if you select track 2 after selecting tracks 1 and 3, the unit automatically reassigns track 2 to pro- gram 06 and track 3 to program 07 (see the screen example below).

<Hint>

To play back a desired loaded track on the current drive, carry out the following operation depending on the load type.

•To play back a track loaded with the type set to “One”:

1.Select the appropriate program to which the track to be played back is loaded by following the procedure below.

See “Selecting a program” on page 71 of the owner’s manual for details about how to select a program.

1-1. Press the [PGM SEL] key.

1-2. Use the [JOG] dial to highlight the appropriate program.

1-3. Press the [ENTER/YES] key.

2.Press the [PLAY] key to start playback of the track.

•To play back tracks loaded with the type set to“Select” or “All”:

1.Select the destination program by following the same procedure as step 1 above.

2.Select a desired track in the program by pressing the [REWIND/PREV] or [F FWD/NEXT] keys while holding down the [SHIFT] key when the recorder is stopped or during playback.

Because all the tracks loaded take part in the same program, you have to select a track within the program.

The VF160EX automatically set an event at the beginning of each track loaded with the type set to “Select” or “All”, so pressing [REWIND/PREV] or [F FWD/NEXT] key while holding down the [SHIFT] key locates to the beginning of the previous or next track, as with a typical CD player on the market (see “Event function” on page 36).

3.Press the [PLAY] key to start playback of the track.

To check events, press the [SCENE STORE/MAP] key while holding down the [SHIFT] key while the recorder is stopped. The display shows the event map, allowing you to check the event positions (in the screen example below, the time base is set to “Bar/Beat/Clk”).

131