Fostex Put back the new hard disk into the VF160EX main unit, Disk and the case

1. Unscrew the four screws fixing the panel to the bottom of the VF160EX main unit.

If the panel is removed, the hard disk covered with a cushion can be seen.

3	Bottom	4
		2
	1

Panel

Cushion

2. Take out the hard disk to the direction “2” indicated in the drawing below.

Slightly lifting up the cushion upward helps you take out the hard disk easily.

When taking it out, do not apply excessive force.

4.Prepare a new hard disk and connect the two cable connectors to it with holding the connector section.

Connector

Hard disk unit

Connector

5. Put back the new hard disk into the VF160EX main unit.

In the reverse order of taking out the hard disk as performed earlier, carefully house the hard disk at the bottom of the main unit and cover it with the cushion.

1

2

1

2

Cushion Hard disk unit

3.Hold the connector section and gently pull out the two cable connectors from the hard disk.

Cushion

Hard disk unit

Hard disk unit

Connector

6.After checking that the cables, etc. are not sticking out from the main unit, put the panel onto the hard

disk and the case.

Align the position of screw holes on the panel / case with the VF160EX bottom panel screw holes and fix the panel / case using the four screws to the VF160EX main unit.

When the new hard disk is successfully assembled, go to the next section. Now, format the unformatted hard disk.

25