Fostex VF160EX 134, Correcting the Registered Time Signature, Deleting a Time Signature

Flashing

The following bar numbers and time signatures can be entered via the [JOG] dial.

Bar	You can enter are from “001”to “999”.
Time	1/4, 2/4, 3/4, 4/4, 5/4, 1/8, 3/8, 5/8, 6/8, 7/8, 8/8
Signature	or “DEL”
	“DEL”is used to deleted time signature data.

6.Next, to register other bar and time signature, repeat steps 2 through 5.

7.Upon completion of registering, press the [EXIT/NO] key (or the [STOP] key) and exit from the SETUP mode.

Correcting the Registered Time Signature

1.Under the previous “Confirmation display,” select bar/ time signatures to be changed and press the [ENTER/ YES] key.

2.Input the desired signature via the [JOG] dial and press the [ENTER/YES] key.

The newly input signature will be setup.

Time	1/4, 2/4, 3/4, 4/4, 5/4, 1/8, 3/8, 5/8, 6/8, 7/8, 8/8
Signature	or “DEL”

“DEL”is used to deleted time signature data.

3.Upon finishing, press the [EXIT/NO] key (or [STOP] key) to exit from the SETUP mode.

Deleting a Time Signature

1.Under the above “Confirmation display,” select bar/time signatures to be deleted and press the [ENTER/YES] key.

2.Press the [ENTER/YES] key again to make “ */* ” to flash and input “DEL” via the [JOG] dial.

Flashing

3.Press the [ENTER/YES] key.

The selected measure/signature setting will be deleted.

4.After deleting, press the [EXIT/NO] key (or [STOP] key) to exit from the SETUP mode.

<Note>

You cannot register the “001BAR“ of “001BAR 4/4 .”

<Note>

Take care because this procedure wipes out the tempo setting as well as time signature setting.

Clearing All Time Signature/Tempo Data

<Note>

Be careful because this procedure wipes out the tempo setting as well as time signature setting.

1.Under the above “Confirmation display,” select “All Clear” and press the [ENTER/YES] key.

A following display of “All Clear,” “SURE ?” will flash. This indicates the standby mode for clearing all signature setting data and the tempo data.

Flashing

2.Press the [ENTER/YES] key.

Except for the initial setting “001BAR 4/4 ,” other time signature settings and the tempo setting will be cleared at the same time.

3.Press the [EXIT/NO] key (or STOP key) to exit from the SETUP mode.

Changing the Bar Offset Figure

1.Under the above “Confirmation display,” select “-002BAR Offset” and press the [ENTER/YES] key.

The “-002” display will change to flashing.

Flashing

2.Input the desired offset value with the [JOG] dial and press the [ENTER/YES] key.

Offset value can be input in the “-2” through “-9” range.

3.After correction, press the [EXIT/NO] key (or [STOP] key) to exit from the SETUP mode.

134