Fostex VF160EX Save/load operation in the CD-DA format, 125, Copy protection setting

Save/load operation in the CD-DA format

Making an audio CD

This section describes how to make an audio CD (CD-DA) using a CD-RW/CD-R disc from mixed-down materials created by the internal mixdown mode. See details for the internal mixdown mode on page 79.

The “Save PGM” menu in the Setup mode, which is used for saving song data, is also used for making an audio CD.

CLIPBOARD IN point		CLIPBOARD OUT point
ABS 0		ABS 05M 00S 00F
	mixed-down song data
	CLIPBOARD IN point	CLIPBOARD OUT point
ABS 0	ABS 00M 10S 00F		ABS 06M 00S 00F

mixed-down song data

<Figure-1>

<Note>

When making an audio CD using the VF160EX, mixed- down materials on the current drive are recorded to a CD-RW/CD-R disc (by the CD-DA format).

Only data between the CLIPBOARD IN and CLIPBOARD OUT points of the mixed-down program is recorded to a CD-RW/CD-R disc. You can record more than one material to a disc successively.

If an audio CD is made using a CD-RW disc, it can be played back only by a player that supports CD-RW playback. You cannot playback such a disc by a conventional CD player that does not support CD-RW playback.

In the following operations, we assume that there are one or more programs which are mixed down by the internal mixdown mode on the current drive.

<Note>

Key operations of the VF160EX should be done after com- pleting access to a CD-RW/CD-R disc.

1.After turning on the power of the VF160EX, load a non-recorded disc to the CD-R/RW drive.

2.Press the [SETUP] key to enter the Setup mode.

3.Use the [JOG] dial to select (highlight) the “Save PGM” menu and press the [ENTER/YES] key.

The display shows the screen for selecting the device to which the data is saved. “IDE” flashes.

Flashing

4.While "IDE" is flashing, press the [ENTER/YES] key.

By pressing the [ENTER/YES] key, the display shows the CD-R/RW drive name, and then changes to the save mode select screen where "Bkup" (Backup) flashes.

To carry out making an audio CD, select “CD-DA”.

If you need to change the copy protection setting (the default setting is “OFF”) and event enable setting (the default setting is "ON"), select “Setup” (for setting writ- ing conditions). If you make an audio CD without chang- ing the copy protection setting, skip steps 5 and 6 below and go to step 7.

F l a s h i n g

5.Use the [JOG] dial to select “Setup” and press the [ENTER/YES] key.

The display shows the “CD-R/RW Setup” screen, on which you can select the copy protection setting and event enable setting.

Copy protection setting

You can restrict the disc copy (duplication) ca- pability of an audio CD you are going to make.

ON	A disc you made can be copied to other digital
	device once.
OFF	A disc you made can be copied to other digital
	device as many times as required (default).

125