Fostex VF160EX Channel view, To turn off the channel view screen, press the EXIT/NO key

4.After completing the parameter setting, press the [EXIT/NO] key.

The VF160EX exits the channel edit mode and the display returns to the Normal display.

<Hints>

If you try to select a channel to which the compressor cannot be applied, a warning message ("Can't Select!") will flash and the operation will be cancelled.

The following screen shows that you can apply the com- pressor to channels 13-14 and the master channel.

Channel view

You can see the current setting information for chan- nels 1 through 16 via the Channel view screen.

1)Channel on/off

2)Fader levels

3)Send levels and pre/post selections for EFF1, EFF2, AUX1 and AUX2.

4)Pan positions

5)Signal destination (stereo busses or Rec busses)

1.Press the [LO-G] key while holding down the [SHIFT] key.

The channel view screen appears.

The first time you bring up the channel parameter edit screen, the message prompting to select a channel ("Select CH!") flashes, as well as all the CH STATUS/CH SEL indicators on the panel flash.

From the second time on, the screen shows the status information of the previously selected channel when bringing up the screen (as shown in the drawing of step 2 below).

Flashing

If two adjacent channels are fader-paired, when press- ing the [CH STATUS/CH SEL] key for the even channel, the fader icon in the figure shown in step 3 above is shown in dotted line.

See page 146 for details about how to pair faders of ad- jacent two channels.

The screen example above shows the following status.

1	Channel 1 is currently selected.
2	The channel is on.
3	The channel fader is set to "00" (-∞).
4	The pan is in the center position.
5	The signal is fed to ST OUT (L/R).
6	The post-fader signal of the selected
	channel is fed to EFF1, EFF2, AUX1 and
9	AUX2 at level 80.

3.To turn off the channel view screen, press the [EXIT/NO] key.

The VF160EX exits the channel edit mode and the display returns to the Normal display.

2.Press the [CH STATUS/CH SEL] key of the desired channel.

The current setting information is shown, together with the channel name.

6 1

7

8

9

2

3 4 5

55