<To specify the desired tracks to "From ** To **">

By rotating the [JOG] dial while the left ("From") field is flashing, you can select the track number from 01 through 24.

The number in the right ("To") field automatically follows the number in the left field (i.e. numbers in the left and right fields are always the same.)

Therefore, if you want to save a single track, you just have to set the right ("From") field and do not have to set the right ("To") field. For example, "From 02 To 02" will save only track 2.

To specify tracks 5 through 12:

Enter "05" to the left field while the left field is flashing.

Press the [F FWD] key to make the right field flashing.

Enter "12". (Note that the number for the right field must be equal to or larger than the left field.)

Finally, the screen shows "From 05 To 12" to save tracks 5 through 12.

10.After entering the file name, press the [ENTER/YES] key.

The save operation is executed and the display shows something like the one as below. As the file save goes on, the remaining data size shown on the screen counts down.

Immediately after the data save to each disc is completed, the disc is automatically ejected, and "Insert Disk" flashes on the screen, prompting you to insert the next disc.

Inserting the next disc resumes the save operation.

After the save operation is completed, "Save Completed!" appears on the screen.

8.After selecting the track(s), press the [ENTER/YES] key.

The display shows the screen for selecting a WAV file on the disc.

You can select "Eject" by rotating the [JOG] dial.

To remove the disc, select "Eject" and press the [ENTER/ YES] key.

Flashing

9.While "WAV" is flashing, press the [ENTER/YES] key.

The display shows the screen for editing the WAV file.

11.Press the [EXIT/NO] key (or the [STOP] key) repeatedly until exiting the Setup mode.

<Note>

When using a CD-RW or CD-R disc on which program data is recorded, pressing the [ENTER/YES] key while "BkUp" is flashing brings up the warning message, fol- lowed by the screen for erasing the existing file, as shown below.

Flashing

By rotating the [JOG] dial, you can set the desired numeric, symbolic or alphabetical character to the flashing point. You can move the flashing point by using the [F FWD] key or [REWIND] key. See the following table for the available characters.

Upper-case alphabetical characters (A to Z)

Numerals (0 to 9)

Symbols (! # $ % & ' ( ) @ ^ _ -)

<Note>

You can use up to 6 characters for a file name.

Some characters entered are converted as shown be- low.

Upper-case alphabetical characters (A to Z): not converted.

Lower-case alphabetical characters (a to z): converted to the corresponding upper-case.

Numerals (! # $ % & ' ( ) @ ^ _ -.): not converted.

Other symbols: converted to "_".

To erase the existing file, select "ERASE" and press the [ENTER/YES] key.

If you do not want to erase the file, select "Eject" and press the [ENTER/YES] key. The disc is ejected and you can replace the disc with another one.

Use the [JOG] dial (or the [REWIND]/[F FWD] keys) to select "ERASE" or "Eject".

<Note>

The erasure operation described above is the "quick erasure". The VF160EX only erases special areas (TOC, etc.) and does not read error after car- rying out the erasure operation above, try to carry out "full erasure" described on page 117.

122

Page 122
Image 122
Fostex VF160EX 122, To specify the desired tracks to From ** To, After entering the file name, press the ENTER/YES key