Fostex VF160EX operation manual 127, If you erase recorded data, If you eject the disc

<Notes for selecting more than one program>

When recording more than one program to a CD- RW/CD-R disc, do not skip any track when assigning programs to tracks.

If you skip any track, you cannot record data to the subsequent tracks. In the following example, track 03 is skipped when assigning programs.

So only tracks 01 and 02 will be recorded. Tracks 03 and subsequent tracks can not be recorded.

<Note>

When making an audio CD, if you select a program which consumes more disc space than the recordable space of a CD-RW/CD-R disc, “Disk Full!” appears on the display and you cannot select the program.

10.After specifying the program(s), press the [ENTER/YES] key while holding down the [RECORD] key.

The VF160EX starts recording to the disc, while the display shows the following screen.

When the recording ends, “Save Completed!” appears on the screen, while the disc is automatically ejected from the CD-R/RW drive.

11.When completed, press the [EXIT/NO] key (or [STOP] key) to quit the Setup mode.

<Hint>

When a CD-RW disc on which any data is recorded is set, if you perform step 7 above (i.e. pressing the [ENTER/ YES] key when “CD-DA” is flashing), “Not Empty!” appears on the display, followed by the screen for selecting whether erasing recorded data or ejecting the disc.

Flashing

Flashing

• If you erase recorded data:

Press the [ENTER/YES] key while “ERASE” and “Sure?” are flashing. After the key press, the display changes as follows and the unit starts erasing the data. As the eras- ing process is going on, the number of flashing “*” in- creases.

Flashing

Flashing

The number of flashing “*” increases.

When erasing is completed, the display shows the same screen which appears when pressing the [ENTER/YES] key after selecting “CD-DA” on step 7 above. So follow the same procedure from step 8 on page 126.

<Note>

The erasure operation described above is the "quick erasure". The VF160EX only erases special areas (TOC, etc.) and does not read error after carrying out the erasure operation above, try to carry out "full era- sure" described on page 117.

• If you eject the disc:

Use the [JOG] dial to make “Eject” flashing and then press the [ENTER/YES] key.

The disc is ejected, while “Insert Disk!” appears on the screen.

When inserting a blank disc, you can go on the next step (see the procedure described above).

127