Setting a tempo Tempo Set, 135 | Fostex VF160EX manual

Setting a tempo [“Tempo Set”]

The “Tempo Map Set” menu enables you to specify a tempo at a given point in a song that already has a time signature setting. For example, you can specify a tempo of 150 to the third beat of the 12th measure.

Time signature and tempo settings make a Tempo Map, which is used by the VF160EX to manage the song using the BAR/BEAT/CLK time base, and enable the metronome function. Tempo settings as well as time signature settings are required when you wish to output MIDI clock and Song Position Pointer to an external sequencer.

<Note>

The tempo set figure setup here is an approximate figure and thus not accurate. Therefore, although the tempo map be matched with a personal computer, they will gradually drift apart. In order to prevent this drift, the personal computer side can be set to either MIDI clock sync or, the MIDI sync output signal temporarily set to “MIDI Clock” the figure reset to make it possible for the computer to read the accurate tempo, and the return it again to MTC sync.

*Initial Setting: 001BAR 1st beat 120 bpm

*Bar to register: Follows to the time signature setting

*Beat to register: Follows to the time signature setting

*Available tempo: 30 ~ 250, DEL (delete)

*Maximum setting points:64

*The setting is applicable song by song.

*The setting can be saved or loaded as a part of the song data

*The setting is memorized even when the power is off.

*Make sure you choose the right program before setting this mode.

2.Input the desired bar with the [JOG] dial and press the [ENTER/YES] key.

The bar value that can be input is identical with the above “signature setup.” When the [ENTER/YES] key is pressed, “beat value” will change to flashing.

3.Input the desired beat with the [JOG] dial and press the [ENTER/YES] key.

The meter value that can be input is identical with the above “signature setup.” When the [ENTER/YES] key is pressed, “tempo value” will change to flashing.

1.Select a program for which to set a tempo setting.

2.Under the menu selection display, select “Tempo Set” and press the [ENTER/YES] key.

The display will change, confirming the current tempo setting. At the initial setting, the display will be as shown below, indicating that tempo of the first beat for the 001 bar is 120 and subsequent tempo is not setup.

“Insert New Event” should be selected at setup of a new tempo. When the [JOG] dial is rotated, the currently displayed items can be selected alternately.

Flashing

4.Input the desired tempo with the [JOG] dial and press the [ENTER/YES] key.

The tempo can be input within the range of 30 through

250.When the [ENTER/YES] key is pressed, the tempo map value thus input will be set and return to the above mentioned “Confirmation display for tempo map.”

5.To register another tempo map, repeat steps 1 through

6.Upon completing registering, press the [EXIT/NO] key (or [STOP] key) to exit from the SETUP mode.

For a setup example, if it is attempted to setup the following tempo in the music that is set to “001BAR 4/4 “ and “005BAR 3/4 “ by the previous “signature setup,” as seen in the music score below, the tempo map must be set as follows.

New Registering of Tempo

1.Under the above “Confirmation display,” select “Insert New Event” and press the [ENTER/YES] key.

The “Insert New Event” section will change to new tempo setup display and “002” will flash. The bar value thus displayed will be the last setup bar value +1 and tempo value will be identical with the last setting (Example: In the initial setup state, “002BAR 1 =120” will be displayed.