Fostex VF160EX operation manual 126, Void In!, Void Out!, or Void Data, Event Enable setting

Event Enable setting

This setting allows you to select whether enabling (ON) or disabling (OFF) the events stored between the clip- board in and clipboard out points when burning a material to an audio CD. See page 128 for details.

	Enables events between the clipboard in and out
ON	points. When making an audio CD, a mastered ma-
	terial is divided into tracks separated by the events
	(default).
	Disables events between the clipboard in and out
OFF	points. When making an audio CD, a mastered ma-
	terial is not divided into tracks (i.e. a material is
	burned as a single track).

To change the setting, press the [ENTER/YES] key when the “CD-R/RW Setup” screen is shown. The current set- ting starts flashing, showing it can be edited.

While flashing, use the [JOG] dial to select “ON” or “OFF”, then press the [ENTER/YES] key to confirm.

6.After setting the copy protection and event enable, press the [EXIT/NO] key.

The display returns to the screen for selecting the save mode, in which “CD-DA” now flashes.

Flashing

9.Use the [JOG] dial to select a desired program and press the [ENTER/YES] key.

The selected program is set to the first track.

Flashing

•To record a single song to a CD-RW/CD-R disc, select a program and press the [ENTER/YES] key, and then go to step 10.

•To record more than one song to a CD-RW/CD-R disc, repeat the procedure for selecting a program described above (i.e. use the [JOG] dial to select a program and press the [ENTER/YES] key) until selecting all desired programs, and then go to step 10.

Flashing

7.While “CD-DA” is flashing, press the [ENTER/YES] key.

After showing “Please Wait!”, the display shows the screen for selecting the program(s) to be record.

In the screen, a number such as “01” or “02” shows the track number, while “NON” shows that no program is assigned to the track.

Flashing

8.Press the [ENTER/YES] key again.

The highest program number available on the current drive starts flashing and its program title and the recording time are also shown. At the top of the program table, the total time of the program is shown.

<Note>

If the program time shows “00: 00” when selecting a pro- gram as the screen example below, the CLIPBOARD IN and CLIPBOARD OUT points are not correctly set.

In other words, in the following conditions, the CLIPBOARD IN and CLIPBOARD OUT points are not regarded as being correctly set.

CLIPBOARD IN point = CLIPBOARD OUT point CLIPBOARD IN point > CLIPBOARD OUT point

If you press the [ENTER/YES] key after selecting such a program, the warning message as below appears on the display and you cannot select the program.

“Void In!”, “Void Out!”, or “Void Data!”

It is possible to select a program that is not mixed down if it holds the correct “IN” and “OUT” points. However, if you record such a program to a CD-RW/ CD-R disc with the audio CD format, only track 1 and 2 can be recorded.

So, make sure that you select programs properly when making an audio CD.

126