Fostex VF160EX Saving on the Memory key and Mark key, Direct Location of Memory key or Mark key

			AUTO RTN
		AUTO PUNCH					CLIPBOARD
	START	IN	OUT		END	IN	ALIGN SEL	OUT
1	2		3	4	5	6		7
					MARK

<Note>

Normally, the [CLIPBOARD-ALIGN SEL/MARK6] key can store the MARK6 memory. When doing a copy/paste (or move/paste) function, the time data stored in the [CLIPBOARD IN] key is automatically copied and stored in this key, allowing you to use it as the ALIGN SEL point. See “Copy/paste and Move/paste” on page 73 for details.

The following details are saved in each Memory Key.

[AUTO RTN-START/MARK 1] Key:

-> START point and MARK 1 memory. [AUTO PUNCH-IN/MARK 2] Key:

-> PUNCH IN point and MARK 2 memory. [AUTO PUNCH-OUT/MARK 3] Key:

-> PUNCH OUT point and MARK 3 memory. [AUTO RTN-END/MARK 4] Key:

-> END point and MARK 4 memory. [CLIPBOARD-IN/MARK 5] Key:

-> CLIP IN point and MARK 5 memory.

[CLIPBOARD-ALIGN SEL/MARK 6] Key:

-> ALIGN SEL point and MARK 6 memory. [CLIPBOARD-OUT/MARK 7] Key:

-> CLIP OUT point and MARK 7 memory.

Saving on the Memory key and Mark key

1.Ensure the system is in the PLAY or STOP status. Press the [HOLD/>] key at the time to save.

The time is held on the LCD at the point the [HOLD/>] key is pressed.

2.Press the [STORE] key (RED: Light ON).

3-1. Press a voluntary Memory key.

The time held is saved as a point of the Memory Key, and then the system returns to the Normal Display.

3-2. Press the [MARK 1-7] key while the [SHIFT] key is depressed.

The time held is saved as a Mark Memory of MARK 1-7, and the system returns to the Normal Display.

Tips: How to check stored time data

To check the memory points, press the desired memory key. To check the mark memory, press the desired memory key while depressing the [SHIFT] key.

2.Press the [LOCATE] key.

This allows Direct Location to the time shown.

Tips: PREROLL

By setting “PREROLL” in the SETUP mode, it is possible to locate the time (0-10 seconds) several seconds before the time set to locate.

Changing the Time Saved in the Memory key and Mark key

1-1. Press a voluntary Memory key.

The name of the key pressed and the point saved appears on the LCD.

1-2. Press the [MARK 1-7] key while the [SHIFT] key is depressed.

The name of the Mark Memory and the time saved appears on the LCD.

Direct Location of Memory key or Mark key

1-1. Press a voluntary Memory key.

The name of the key pressed and the point saved appears on the LCD.

1-2. Press the [MARK 1-7] key while the [SHIFT] key is depressed.

The name of the Mark Memory and the time saved appears on the LCD.

2.Change the parameter of the flashing column (cursor) (H/M/S/F/SF or BAR/BEAT/CLK) using the [JOG] dial.

Move the flashing column (cursor) by pressing the

[HOLD/>] key.

3.Press the [STORE] key (RED: Light ON).

3-1. Press a voluntary Memory key.

The time modified is saved as the time point of the Memory Key, and the system returns to the Normal Display.

3-2. Press the [MARK 1-7] key while the [SHIFT] key is depressed.

The time modified is saved as a Mark Memory of MARK 1-7, and the system returns to the Normal Display.

35