Fujitsu IRMC S2/S3 manual Proceed as follows Open a DOS prompt window

Using AVR

IThe settings for the mouse pointer synchronization are supported only for the operating system which runs the managed server.

If the software which controls the mouse is active, sometimes the mouse pointer cannot be synchronized.

5.2.5.2Managed Windows server:

Adjusting the settings for synchronization of the mouse pointers

On a Windows server, you can either make the settings for mouse pointer synchronization using a batch program or using the Windows Start menu and the context menu.

You must adjust the following settings:

–Speed of the mouse pointer

–Hardware acceleration

IWhen you adjust the settings using a batch program, the Matrox graphics driver is installed as well as the mouse pointer speed and hardware acceleration being adjusted.

You can make all the settings for the managed server either directly at the managed server or from the remote workstation over AVR.

Adjusting the settings on the managed server using a batch program

Proceed as follows:

ÊOpen a DOS prompt window.

ÊSwitch to the folder in which the batch program install_kronos2_vga.bat for the relevant Matrox VGA driver installation (32-bit or 64-bit) is located.

IBy default, you will find the install_kronos2_vga.bat programs under:

C:\Program Files\Fujitsu\ServerView Suite\Installation Manager\ Content\V10.09.12.00\DRV\VIDEO\MATROX\iRMC\W2K

and on your ServerView Suite DVD 1.

ÊType setup.bat to start the batch program.

ÊReboot the managed server when the batch program has executed.

iRMC S2/S3 95