Configuring the LAN interface of the iRMC S2/S3

3.1.1.2Interaction between the IP addresses of the iRMC S2/S3 and the system

The LAN controller of the PRIMERGY server requires a separate IP address for the iRMC S2/S3 in order to ensure that data packets are reliably transferred to the iRMC S2/S3 (and not to the operating system).

The IP address of the iRMC S2/S3 must be different from that of the system (operating system).

3.1.1.3Access from a different subnet

If the remote workstation accesses the iRMC S2/S3 of the managed server from a different subnet and DHCP is not used, you must configure the gateway.

3.1.2Configuring the LAN interface: Configuration tools

You can configure the iRMC S2/S3’s LAN interface in a number of ways:

Depending on the type of the PRIMERGY server

using the BIOS / TrustedCore / UEFI setup utility (see page 44),

iRMC S2/S3 web interface (see section "Network Settings - Configure the LAN parameters" on page 238),

using the Server Configuration Manager (see chapter "Configuring iRMC S2/S3 using the Server Configuration Manager" on page 347).

iRMC S2/S3

43

Page 43
Image 43
Fujitsu IRMC S2/S3 manual Configuring the LAN interface Configuration tools, Access from a different subnet