Fujitsu IRMC S2/S3 manual Prerequisites, Configuring the LAN interface of the iRMC S2/S3

Configuring the LAN interface of the iRMC S2/S3

3.1.1Prerequisites

Note the following requirements with respect to configuring the IP address:

–The LAN cable must be connected to the correct port. (see section "Connected to the correct LAN port?" on page 42).

–Interaction between the IP addresses of the iRMC S2/S3 and the system (see the section "Interaction between the IP addresses of the iRMC S2/S3 and the system" on page 43).

3.1.1.1Connected to the correct LAN port?

The interface for a LAN connection is provided on an onboard LAN controller assigned to the iRMC S2/S3 (see also figure 4 on page 27).

Depending on the server type, the system board of a PRIMERGY server provides two or three LAN interfaces. The ports marked with a wrench symbol are assigned to the iRMC S2/S3 (in figure 7, for example, these are port 1 and the top left-hand port).

ICheck that the LAN cable is connected to the correct port.

Depending on the type of PRIMERGY server, different ports may be marked with the wrench symbol.

Dedicated Service / Management LAN

(port exclusively for the

iRMC S2/S3; with the iRMC S3 a LAN speed up to 1000 MBit/s is available, depending on the server hardware.)

(1)	Shared LAN
	(iRMC S2/S3 and system)

(2) LAN (port exclusively

for the system)

Figure 7: Ports for the iRMC S2/S3 (indicated by wrench symbol)

42 iRMC S2/S3