Network Settings - Configure the LAN parameters

VCAUTION!

Contact the network administrator responsible for the system before you change the Ethernet settings.

If you make illegal Ethernet settings for the iRMC S2/S3, you will only be able to access the iRMC S2/S3 using special configuration software, the serial interface or via the BIOS.

IOnly users with the Configure iRMC S2/S3 Settings permission are allowed to edit Ethernet settings (see chapter "User management for the iRMC S2/S3" on page 65).

Network Interface Settings

MAC Address

The MAC address of the iRMC S2/S3 is displayed here.

LAN Speed

LAN speed. The following options are available:

Auto Negotiation

1000 MBit/s Full Duplex (depending on the server hardware)

100 MBit/s Full Duplex

100 MBit/s Half Duplex

10 MBit/s Full Duplex

10 MBit/s Half Duplex

If Auto Negotiation is selected, the onboard LAN controller assigned to the iRMC S2/S3 autonomously determines the correct transfer speed and duplex method for the network port it is connected to.

LAN Port

IThis option is not supported for all PRIMERGY servers.

On some PRIMERGY server models, the LAN interface of the installed system NIC (network interface card) can be set up

as shared LAN for shared operation with the system or

as a service LAN for exclusive use as a management LAN.

240

iRMC S2/S3

Page 240
Image 240
Fujitsu IRMC S2/S3 manual Network Interface Settings, MAC address of the iRMC S2/S3 is displayed here