D Regulatory information
FCC statement
The United States Federal Communications Commission (in 47 cfr 15.105) has specified that the following notices be brought to the attention of users of this product.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Shielded cables
Use of a shielded data cable is required to comply with the Class B limits of Part 15 of the FCC Rules.
Pursuant to Part 15.21 of the FCC Rules, any changes or modifications to this equipment not expressly approved by the
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
zReorient or relocate the receiving antenna.
zIncrease the separation between the equipment and receiver.
zConnect the equipment into an outlet on a circuit different from that to which the receiver is connected.
zConsult the dealer or an experienced radio/TV technician for help.
| Exposure to radio frequency radiation |
|
|
CAUTION | The radiated output power of this device is far below the FCC radio frequency exposure limits. |
| Nevertheless, the device shall be used in such a manner that the potential for human contact |
| during normal operation is minimized. |
| This product and any attached external antenna, if supported, shall be placed in such a manner |
| to minimize the potential for human contact during normal operation. In order to avoid the |
| possibility of exceeding the FCC radio frequency exposure limits, human proximity to the |
| antenna shall not be less than 20cm (8 inches) during normal operation. |
|
|
ENWW | 93 |
