4.For the HP JetDirect card that will be installed into the upper slot, remove the front plate by removing the two side screws (A).

•If your HP JetDirect card is a Token Ring card, also remove the mounting screws (B) from the front plate.

•The front plate should separate from the card. Save this front plate for future use, if desired.

Remove faceplate from card

5.Obtain the appropriate custom cover plate for your card. Remove the plastic clip and screws from the rear of the cover plate. Save the clip—you will use it later in the installation process.

Custom cover plate for Token Ring card

Installation 2

Installing the HP JetDirect Print Server Card 2-21