To configure a NetWare frame type
If you haven't already done so, enable Novell NetWare by following the instructions described in “To enable or disable network protocols” in this chapter.
For the 600 Series Printers
1.Access the configuration menu (see “To enable or disable network protocols” in this chapter).
2.Press ↑ until Novell→ or Auto→ appears.
3.Press ↑. MIO SETUP and FRAME=<current frame type>→ appear.
4.To maintain the current frame type, press ↑.
5.To change frame type, proceed as follows:
a.Press [Enter] to display the current frame type.
b.Press ↑ until the frame type you want appears.
c.Press [Enter] to save the new frame type.
For the 700/2000/2500/3000/3500 Series Printers
1.Access the configuration menu (see “To enable or disable network protocols” in this chapter).
2.From the CFG IPX/SPX=NO→ menu item, press [Enter], ↓,
[Enter] to display CFG IPX/SPX=YES→ .
3.Press ↑ to display FRAME=AUTO.
4.To change the frame type, press [Enter] and ↓ until the frame type you want is displayed. Press [Enter] to select the frame type.
5.Press [Previous] and return to STATUS Ready.
6.To save the configuration, print a configuration plot by pressing the two arrow keys simultaneously. Your printer configuration is now active.
To manually configure other parameters, see the appropriate sections in this chapter.
To complete the print server configuration, see the HP JetDirect software installation guide included with the product.
HP DesignJet 4 Control Panel
Control Panel for
