To enable or disable network protocols
NOTE | For HP 2500C/CM Professional Series |
| and DesignJet ColorPro GA printers, see the |
| |
| ColorPro GA Control Panel” instructions at the |
| end of this chapter. |
|
|
1.Take the printer offline by pressing [On Line] or [Go] to indicate offline.
2.Press [Menu] repeatedly until the following message is displayed on the control panel:
4 Series printers | AUX IO MENU | |
4 Plus and 4V Series printers | MIO MENU |
|
Color LaserJet printers | MIO CONFIG MENU | |
(Proceed to Step 4) | CFG NETWORK=NO * | |
4Si Series printers (select the | MIO MENU | 1 or |
card slot being configured) | MIO MENU | 2 |
5Si Series printers (select the | HP MIO 1 | MENU or |
card slot being configured) | HP MIO 2 | MENU |
5 Series printers | HP MIO MENU | |
3.Press [Item] until CFG NETWORK=NO* appears. This message does not mean that you must reconfigure your protocol. It means only that you do not intend to access the network configuration menus.
4.Change the message to CFG NETWORK=YES* using the following buttons:
5 Series and 5Si Series printers | Press [+], then [Select] |
Other printers | Press [+], then [Enter] |
5.Press [Item] to scroll through each network protocol until the one you want to change is displayed.
6.To maintain the status of the protocol, press [Item].
7.To change the protocol status, press [+], and then press [Select] or [Enter] depending on your printer model.
Control Printer 3 Panel
Using the Control Panel for Printers