Configuring Apple EtherTalk Phase Parameters (Ethernet Cards Only)
You can configure Apple EtherTalk parameters if the Apple EtherTalk protocol is enabled (ETALK=ON*), and the PostScript printer language is enabled.
To ensure the PostScript printer language is enabled, check the Configuration Menu (for 5Si Series printers) or the JOB MENU (for other printers). PERSONALTY=PS* or PERSONALTY=AUTO* should be set.
To configure EtherTalk parameters
NOTE | For HP 2500C/CM Professional Series |
| and DesignJet ColorPro GA printers, see the |
| “HP 2500C/CM Professional Series and DesignJet |
| ColorPro GA Control Panel” instructions at the |
| end of this chapter. |
|
|
If you haven’t already done so, enable EtherTalk by following the instructions described in “To enable or disable network protocols” in this chapter.
1.Take the printer offline by pressing [On Line] or [Go] to indicate offline.
2.Press [Menu] repeatedly until the following message is displayed on the control panel:
4 Series printers | AUX IO | MENU | |
4 Plus and 4V Series printers | MIO MENU |
| |
Color LaserJet printers | MIO CONFIG MENU | ||
(Proceed to Step 4) | CFG NETWORK=NO * | ||
4Si Series printers (select the | MIO MENU | 1 or | |
card slot being configured) | MIO MENU | 2 | |
5Si Series printers (select the | HP MIO | 1 | MENU or |
card slot being configured) | HP MIO | 2 | MENU |
5 Series printers | HP MIO | MENU | |
3. Press [Item] until CFG NETWORK=NO* appears.
