HP 400N manual To configure NetWare source routing

Configuring Novell NetWare Source Routing (Token Ring Cards Only)

You can select the method for Novell NetWare Token Ring source routing from the control panel. The possible routing methods are:

•AUTO (default): Source routing is enabled if necessary.

•OFF: All packets are sent without source routing—packets are received only if they originate from the same ring.

•SINGLE R: All packets are sent with source routing. The Single Route method is used for broadcasts and when the route is unknown.

•ALL RT: All packets are sent with source routing. The All Routes method is used for broadcasts and when the route is unknown.

You can configure the NetWare source routing if NetWare is enabled and you have installed a Token Ring print server.

To configure NetWare source routing

NOTE	For HP 2500C/CM Professional Series and
	DesignJet ColorPro GA printers, see the “HP
	2500C/CM Professional Series and DesignJet
	ColorPro GA Control Panel” instructions at the end
	of this chapter.

If you have not already done so, enable Novell NetWare (IPX/ SPX=ON*) by following the instructions described in “To enable or disable network protocols” in this chapter.

1.Take the printer offline by pressing [On Line] or [Go] to indicate offline.

2.Press [Menu] repeatedly until the following message is displayed on the control panel:

4 Series printers	AUX IO MENU
4 Plus and 4V Series printers	MIO MENU
Color LaserJet printers	MIO	CONFIG MENU
(Proceed to Step 4)	CFG	NETWORK=NO *

3 Printer Control Panel

Using the Control Panel for Printers 3-7